Installing a Two piece Freestanding Tub-assembled with screws

The installation instructions for the Flex P-trap drain can’t be used together with installation instruction of a Freestanding Tub. The strain draining should come already installed by the manufacturer, but if not you can use the Strain draining installation guide provided by manufacturer. It is impossible to fit (adjust) the freestanding tub with a rigid p-trap without resulting in leaking later. Because of the part tolerances and the incorrect installations of tub, the freestanding tub will leak or sewer gases will escape in the bathroom.The Flex P-trap will eliminate all these problems. If the manufacturer does not supply a P-trap, you can use Flex P-trap and these installation instructions.

Step-by-step installation instructions for one-piece Freestanding Tub-assembled with screws

First, you have to check the Installation instruction of freestanding tub.

Second, check the space under the floor.

Third, choose between Flex BP-trap/14 or Flex CP-trap/18.

Fourth, follow the installation instructions listed below.

• Step 1. Place the Freestanding Tub in the instaled position on the floor and trace the outline of the bath with a pencil or erasable marker.

Step 1	Step 2	Step 3
Step 4	Step 5	Step 6

• Step 2. Choose the Flex BP-trap/14 or Flex CP-trap/18 and cut the floor. Install the draining line in the middle of floor opening. (see the installation instruction of Flex BP-trap/14 or Flex CP-trap/18)

• Step 3. Turn upside down the tub over blanket and disassemble the freestanding tub

• Step 4. Check the leveling of legs and adjust the legs of tub to be the same level

• Step 5. Check the outside part of tub (part 1)

• Step 6. Install the faucet if the tub has one, otherwise skip steps 6 and 7

• Step 7. Lift up the tub with wood blocks to protect the faucet and assemble the tub.

• Step 8. If the freestanding tub doesn't have a faucet, turn the tub upside down (part 2) and assemble the freestanding tub.

• Step 9. Lift up the tub with 4x4 wood blocks and connect the Flex P-trap. Follow the installation instruction of the Flex BP-trap/14 or Flex CP-trap/18.

• Step 10. Apply tile caulk around the bottom edge of the bathtub.